Names And Functions Of Indications On The Remote Controller - Toshiba RAS-M10SMUV-E Manual Del Propietário

NAMES AND FUNCTIONS OF INDICATIONS ON THE REMOTE
CONTROLLER
Display
All indications, except for the clock indication, are displayed by pushing the START/STOP button.
a Transmission mark
This transmission mark
to the indoor unit.
b Mode display
Indicates the current operation mode.
• Heat Pump model
(AUTO: Automatic control, A: Auto changeover control,
: Heat)
• Cooling Only model
(AUTO: Automatic control, A: Auto changeover control,
: Fan only)
c Temperature display
Indicates the temperature setting (17°C to 30°C).
When you set the operating mode to
displayed. (for Cooling only model)
d FAN speed display
Indicates the selected fan speed. AUTO or one of five fan speed levels (LOW
LOW+ , MED , MED+
AUTO is displayed when the operating mode is either in AUTO or
e TIMER and clock display
The time set for timer operation or the clock is displayed.
The present time is always indicated except when in TIMER operation.
f High power display
Indicates when the High power operation starts.
Push the Hi POWER button to start and stop the operation.
g
(MEMORY) display
Flashes for 3 seconds when the MEMO button is pushed during operation.
mark is displayed when the button is not pushed for more than 3 seconds while
the mark is flashing.
Push another button to turn off the mark.
h ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display changes in sequence between 1,
3, 5, or 9h.
i A, B change indicatior remote controller
When the remote controller switching function is set, "B" appears on the remote
controller display.
(When the remote controller setting is "A" there is no indication in this position.)
Remote controller switching function
• If two indoor units are installed in the same room or adjoining rooms, both units
may start and stop at the same time when the remote controller is operated.
This can be prevented by setting the switching function so that each indoor unit
is operated only by the corresponding remote controller.
• To use the remote controller switching function, contact the air conditioner
dealer or the installation company.
Resetting of the remote controller switching
To exchange the battery while using remote controller switching function, reset the
remote controller switching.
• Exchange the battery with a new one.
• Push the "CHECK" point and "MODE" button at the same time, to change the
remote controller setting from "A" to "B". (Priority is given to "A" setting.)
• Check that the changed remote controller can or cannot operate the indoor unit.
indicates when the remote controller transmits a signal
: Fan only, no temperature setting is
, HIGH ) can be displayed.
: Cool, : Dry,
: Cool, : Dry,
,
• In the illustration, all indications are
indicated for explanation.
During operation, only the relevant
: Dry.
indications will be displayed on the
remote controller.
7 EN