Connecting The Coolant - Abicor Binzel ROVO VTS Serie Instructivo De Servicio

VTS torch system

6.8 Connecting the coolant

1
1 Coolant return hose
Fig. 8 Connecting the coolant
WARNING
Risk of burns
The torch will become overheated by welding without coolant or if the
coolant level is too low.
• Wear protective gloves.
• Check the coolant level at regular intervals.
NOTE
• Applies only to liquid-cooled VTS torch system.
• Make sure that the coolant supply and return have been installed
properly. Coolant supply = blue, coolant return = red.
• Do not use any deionized or demineralized water as coolant or for
tightness or flow tests.
This may impair the service life of your welding torch.
• For the liquid-cooled VTS torch system, we recommend using the
ABICOR BINZEL coolant BTC-15.
2 Re-circulating cooling unit
6 Putting into operation
2
3
3 Compressed air hose
EN - 13