Connecting The Cable Assembly On The Machine Side; Connecting The Control Lead; Setting The Shielding Gas Quantity - Abicor Binzel ROVO VTS Serie Instructivo De Servicio

6 Putting into operation

6.5 Connecting the cable assembly on the machine side

6.6 Connecting the control lead

White
Brown
Green
Yellow
Gray
Black
Purple
Tab. 8
10-wire control lead circuit diagram

6.7 Setting the shielding gas quantity

EN - 12
1 Mount central connector to the wire feeder and secure it with the
connection nut.
2 Fasten the air-blast hose to the air-blast and spraying unit or the air-blast
valve. Seal the connection gas-tight if the "Cleaning with compressed air"
option is not used.
The control lead is open on the machine side. The customer has to provide the
connection of a suitable plug. If all data are provided, the cable assembly can
also be delivered ready-to-connect. Connect the connector by soldering as
follows:
- Emergency Stop 2
- Emergency Stop 3
- Emergency Stop 1
-
-
- Wire feeder
- Wire feeder
NOTE
• The type and quantity of the shielding gas quantity depends on the
welding task and the gas nozzle geometry.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly, before connecting
the cylinder. This will blow out any impurities that may be present.
• Make all shielding gas connections gas-tight.
1 Connect central connector to the feed unit.
2 Set the gas quantity on the pressure reducer.
VTS torch system