Testing Seat Clamp And Post Clamp Tightness; Front And Rear Refl Ector Installation - Huffy HCoaster Serie Manual Del Propietário

Testing Seat Clamp and Post Clamp Tightness

To test the tightness of the seat clamp and the post clamp:
WARNING
:
Every time the quick release mechanism is loosened, make sure
the red refl ector is correctly positioned.
• Try to turn the seat side-to-side and to move the front of the seat up and down.
• If the seat moves in the Seat Clamp:
• Loosen the Seat Clamp.
• Put the seat in the correct position and tighten the Seat Clamp tighter than before.
• Do this test again, until the seat does not move in the Seat Clamp.
• If the Seat Post moves in the Seat Tube:
• Move the Quick Release Lever to the "open" position.
• Put the seat in the correct position and tighten the Quick Release Lever tighter than
before.
• If necessary, loosen Quick Release Lever, tighten Adjusting Nut and re-tighten Quick
Release Lever.
• Do this test again, until the seat post does not move in the seat tube.
Refl ector Installation (as equipped)
Refl ector Installation:
A
1. Position FRONT Refl ector so it points
straight forward.
2. Tighten Clamp Screw.
3. Position Seat Post Refl ector (if equipped)
B
so it points straight backwards.
4. Tighten Clamp Screw.
NOTE: Do not over-tighten. This will damage
the Clamp.
DUAL REAR REFLECTORS (VARIOUS MOD-
ELS):
A
The Rear Refl ectors are may be pre-installed
on the bike chain stays. Make sure they are
secure, not bent and are pointing straight
backwards.
Installation (as needed):
A
• Place Refl ector in position as shown and
attached with two supplied Screws
• Tighten securely. Do not over tighten.
14
B
A
1
A
B
B
.
Installation du circuit de freinage – suite
1
1-1
Vue éclatée No 1 :
• Desserrer l'écrou du câble
soit lâche.
Vue éclatée No 2 :
• Insérer le cylindre de réglage du câble
dans la manette de frein.
Vue éclatée No 3 :
• Insérer le câble du frein
qu'illustré.
Vue éclatée No 4 :
2
• Faire pivoter la rainure de la gaine
sens opposé à la rainure du câble

l'écrou de la gaine
B
3
2
3

, afi n que le câble


dans la rainure tel
4

dans le

et serrer
.
2-1
3-1
4-2
4-1
4-3
19