Hints And Tips - Zanussi ZWI 71000 WA Manual De Instrucciones

The indicator flashes.
2. Change the options.
3. Press the button Inicio/Pausa again.
The programme continues.
OPENING THE DOOR
While a programme or the delay start operates, the
appliance door is locked.
CAUTION! If the temperature and
level of the water in the drum are too
high and the drum still rotates, you
cannot open the door.
To open the door during the first minutes of the
cycle or when the delay start operates:
1. Press the button Inicio/Pausa to pause the
appliance.
2. Wait some minutes until the door unlocks.
3. You can open the door.
4. Close the door and touch the button Inicio/
Pausa again. The programme (or the delay)
continues.
AT THE END OF THE PROGRAMME
• The appliance stops automatically.
• The indicator of the button Inicio/Pausa goes
off. The phase indicator Fin/Fim illuminates and
stays on.
• Turn the programme knob to position
deactivate the appliance.
• After some minutes you can open the door.
• Remove the laundry from the appliance. Make
sure that the drum is empty.
• Close the water tap.

HINTS AND TIPS

THE LAUNDRY LOAD
• Divide the laundry in: white, coloured,
synthetics, delicates and wool.
• Obey the washing instructions that are on the
laundry care labels.
• Do not wash together white and coloured items.
• Some coloured items can discolour with the first
wash. We recommend that you wash them
separately for the first times.
• Button up pillowcases, close zippers, hooks and
poppers. Tie up belts.
• Empty the pockets and unfold the items.
• Turn inside out multilayered fabrics, wool and
items with painted illustrations.
• Remove hard stains.
• Wash with a special detergent heavy soil stains.
• Keep the door and the detergent drawer ajar, to
prevent the mildew and odours.
The washing programme is completed, but
there is water in the drum:
• The drum turns regularly to prevent the creases
in the laundry.
• The indicator
• The indicator Inicio/Pausa flashes to remind you
to drain the water.
• You must drain the water to open the door.
Draining the water:
1. Set a draining (Descarga) or a spinning
(Centrifugar) programme.
2. Press the button Inicio/Pausa.
The appliance drains the water and spins.
3. When the programme is completed:
• The indicator Inicio/Pausa goes off and the
phase indicator Fin/Fim illuminates.
• After some minutes the door unlocks; you
can now open the door.
4. Turn the programme knob to the position
deactivate the appliance.
STAND BY
Some minutes after the end of the washing
programme, if you do not deactivate the appliance,
the energy saving status activates. The energy
saving status decreases the energy consumption
when the appliance is on the standby:
to
• All indicators go off.
• The indicator of the button Inicio/Pausa flashes
slowly.
Press one of the buttons to deactivate the energy
saving status.
• Be careful with the curtains. Remove the hooks
or put the curtains in a washing bag or
pillowcase.
• Do not wash in the appliance laundry without
hems or with cuts. Use a washing bag to wash
small and/or delicate items (e.g. underwired
bras, belts, tights, etc. ).
• A very small load can cause balance problems
with the spin phase. If this occurs, adjust
manually the items in the tub and start the spin
phase again.
STUBBORN STAINS
For some stains, water and detergent is not
sufficient.
We recommend that you remove these stains
before you put the items in the appliance.
stays on.
to
11