Zanussi ZWI 71000 WA Manual De Instrucciones página 10

USING DETERGENT AND ADDITIVES
DETERGENT COMPARTMENTS
Detergent compartment for prewash
phase.
Detergent compartment for washing
phase.
Compartment for liquid additives
(fabric conditioner, starch).
SETTING A PROGRAMME
1. Turn the programme knob clockwise or
counterclockwise to switch the appliance on
and set the programme:
The indicator of Inicio/Pausa button flashes.
2. If necessary, change the spin speed or add
available options.
When you activate an option, the indicator of the
set option comes on.
If you turn the programme knob to
another programme when the
appliance is working, the red indicator
of Inicio/Pausa button will blink to
indicate a wrong selection.
STARTING A PROGRAMME WITHOUT THE
DELAY START
Press the button Inicio/Pausa.
10
CAUTION!
Make sure
that no
laundry stays
between the
seal and the
door. There
is a risk of
water
leakage or
damage to
the laundry.
1. Measure out the
detergent and the
fabric conditioner.
2. Carefully close the
detergent drawer.
The corresponding indicator stops to flash.
The phase indicator Prelava./Lava. illuminates and
stays on.
The programme starts and the door locks.
The drain pump can operate for a
short time at the beginning of the
washing cycle.
STARTING A PROGRAMME WITH THE DELAY
START OPTION
1. Press the button Inicio Diferido repeatedly to
set the required delay.
The indicator of the set delay comes on.
2. Press the button Inicio/Pausa:
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the delay
setting before you press the button
Inicio/Pausa. After pressing the button
Inicio/Pausa, you can only cancel the
delay.
To cancel the delay start:
a. Press the button Inicio/Pausa to set the
appliance to pause.
The corresponding indicator flashes.
b. Press the button Inicio Diferido once; the
indicator of the set delay goes off.
Press the button Inicio/Pausa again to start
the programme immediately.
CANCELLING A RUNNING PROGRAMME
1. Turn the programme knob to position
cancel the programme and to deactivate the
appliance.
2. Turn the programme knob again to activate the
appliance. Now, you can set a new washing
programme.
Before starting the new programme
the appliance could drain the water. In
this case, make sure that the detergent
is still in the detergent compartment, if
not fill the detergent again.
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Press the button Inicio/Pausa.
to