Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.
USE
7R VZLWFK RQ WKH OLJKW
- Press the Up button.
7R WXUQ RII WKH OLJKW
- Press the Down button.
The "my" button has no effect.
8. ADDITIONAL SETTINGS
8.1. Adding/Deleting Somfy io local control points
A maximum of 9 control points can be programmed
in a Lighting Receiver On/Off io.
1) Press the PROG button on the programmed control
SRLQW D XQWLO WKH OLJKW JRHV RQ WKHQ JRHV RII WKH /LJKWLQJ
Receiver io is now in programming mode for 10 minutes.
2) %ULHÀ\ SUHVV WKH 352* EXWWRQ RQ WKH 6RPI\ ORFDO LR
FRQWURO SRLQW E WR EH DGGHGGHOHWHG WKH OLJKW JRHV RQ WKHQ
goes off; the io control point is added or deleted.
8.2. Replacing a lost or broken Somfy io control point
Refer to the corresponding guide.
5HVWRULQJ WKH RULJLQDO FRQ¿JXUDWLRQ
This reset is done with a Somfy io local control point.
This reset deletes all control points.
Only perform the double cutout on the Lighting
Receiver On/Off io to be reset.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 5 to 15 seconds.
3) Cut the power supply for 2 seconds.
6ZLWFK WKH SRZHU VXSSO\ EDFN RQ WKH OLJKW ÀDVKHV VORZO\
+ROG GRZQ WKH 352* EXWWRQ WKH OLJKW FRPHV RQ WKHQ
goes off, and a few moments later the light comes on again.
7KH /LJKWLQJ 5HFHLYHU LR LV QRZ LQ IDFWRU\ FRQ¿JXUDWLRQ
- Repeat the procedures in the "Set-up" section.
8
1
2
1
2 sec.
PROG. A
1
2 sec.
PROG. A
1
2 seconds.
3
2 seconds.
5
PROG. A
© 2013 Somfy SAS. All rights reserved. 09/2013
+
2
0.5 sec.
PROG. B
+
+
2
0.5 sec.
PROG. B
5 seconds.
2
OFF
ON
15 seconds.
4
OFF
ON
10 min.
10 min.
Capítulos
Tabla de contenido
