Idiomas disponibles
Idiomas disponibles
Installation Instructions – WaveStream Linear
Sensor Option Installation: (Row Mount only) Section
(Step 1-5)
1.
Rotate upper endplate, bend flange as shown and
rotate back to its original position in the Channel
assembly. (Figure 34.)
Flange
Endplate
Flange
Figure 34.
2.
Insert Channel Joiner to one of the channels and insert
another channel to the other end of Channel Joiner. This
creates a gap between fixture to install sensor.
Figure 35.
8
COOPER LIGHTING SOLUTIONS
Channel Joiner
Installation instruction
IB519017EN
3.
Install screws to secure Channel Joiner.
Figure 36.
4.
To install waveguide assemblies repeat the steps 4 to 9
from Row Mount Installation.
5.
The Rowtrim includes the sensor preassembled.
Connect the RJ11 cable coming from the end of the
fixture to the pigtail in the sensor. Snap Rowtrim in
place. Assure all wiring is covered in the Rowtrim.
Screws
