Idiomas disponibles
Idiomas disponibles
Installation Instructions – WaveStream Linear
5.
Wire fixture according to code and install channel cover
to channel with provided screws. (Figure 23.)
Channel Cover
Figure 23.
6.
Remove waveguide assembly from box and slide it into
the channel assembly.
Figure 24.
7 .
Secure the waveguide assembly to channel assembly
with screws provided, (Figure 25.) (One side of the
fixture only) (Use a long bit or right angle tool).
Figure 25.
8.
Connect LED wire harness on each end of the
waveguide assembly. (Figure 26.)
Fixture harness
Waveguide assembly harness
Figure 26.
6
COOPER LIGHTING SOLUTIONS
Channel
Screw
Channel
Slide
Assembly
Waveguide
assembly
Installation instruction
IB519017EN
9.
To install safety cable remove screw from channel
assembly and reattach safety cable with the same
screw. (Figure 27 .)
Figure 27.
10. For 8ft fixture two sets of waveguide assemblies are
included. Repeat steps 6 to 9.
11. Remove protective film from waveguides and tuck wire
harness between waveguides. Install Trim provided,
between waveguides.
Row
Trim
Figure 28.
For End of Row Section (Step 12)
12. Remove endcaps from parts box, install Endcap to
fixture. Tuck wire harnesses and safety cable while
installing. Endcap tabs must fully engage in the metal
Screw
bracket. (Figure 29.)
Figure 29.
If fixtures have an up-light component install the
N
ote:
fixtures with the harness on the same side for
consistency purposes.
Screw
Endcap
Endcap Tabs
Sheet metal Bracket
in Waveguide
Safety Cable
