Idiomas disponibles
Idiomas disponibles
8 ft. – Standalone Installation
1.
Remove channel assembly from box, remove tape
around channel cover and install on surface or
suspended ceiling according to code (hardware
provided by others).
Openings at both ends can
be used for surface mounted
or suspended applications
Figure 8.
2.
Wire fixture according to code and install channel cover
to channel with provided screws. (Figure 9.)
Channel Cover
Figure 9.
3.
Remove the waveguide assembly from the box and
slide it into the channel assembly.
Waveguide
assembly
Figure 10.
Channel
Channel
Slide
Assembly
Installation Instructions – WaveStream Linear
4.
Secure the waveguide assembly to channel assembly
with screws provided, (Figure 11.) (One side of the
fixture only) (Use a long bit or right angle tool).
Figure 11.
5.
Connect LED wire harness on each end of the
waveguide assembly. (Figure 12.)
Waveguide assembly harness
Figure 12.
6.
To install safety cable remove screw from channel
assembly and reattach safety cable with the same
screw. (Figure 13.)
Figure 13.
COOPER LIGHTING SOLUTIONS
Screw
Fixture harness
Screw
IB519017EN
Installation instructions
Safety
Cable
3
