Operating From The Remote Control - DeLonghi AN125HPEK Instrucciones De Uso

Maximum speed: for maximum fan power.
HEATING MODE
This is ideal in spring and autumn when outdoor temperatures
are not particularly severe. For this mode, the appliance should
be prepared in the same way as for air conditioning, with the
air exhaust hose (B2) attached to enable the moisture to be dis-
charged outside. To set this mode:
• Press repeatedly the MODE button until the heating sym-
bol is displayed.
• Press + (C3) or - (C6) buttons to adjust the desired tem-
perature.
Note:
•
In this mode, fan speed is selected automatically by the ap-
pliance and cannot be set manually.
• When operating in very cold rooms, the appliance defreez-
es automatically, momentarily interrupting normal opera-
tion. " Lt " appears on the display. During this operation, it
is normal for the noise made by the appliance to change.
• In this mode, you may have to wait a few minutes before
the appliance starts giving out hot air.
• In this mode, the fan may operate for short periods, even
though the set temperature has already been reached.
• It may happen that the display shows "HL" alarm. In this
case, empty the internal safety tan following the instruc-
tion in the Section "End of Season operatons". At the end,
press again the button to restore the heating function.
SETTING THE TIMER
The timer can be used to delay appliance start up or shutdown.
This avoids wasting electricity by not operating the appliance
when it is not needed.
How to program delayed start up
• Plug the appliance into the electrical receptacle and turn
the unit to standby.
• Press the timer button (C4): the timer symbol (C13) and
the number of hours come on.
• Use the + (C6) or - (C3) buttons to set the number of hours
delay before the appliance comes on.
• A few second after set, the setting is memorised, the timer
symbol is lit and the display shows that the appliance is in
standby.
• The appliance will start wor ing using the mode previously
set. The appliance can be set to come on within the next 24
hours.
To delete the setting, press two times the timer button (C4). The
timer symbol (C13) switches o .
How to program delayed shutdown
• With the air conditionier on, in every mode, it is possible to
set the delayed shutdown.
• Press the Timer (C4) button: the timer symbol (C13) and
the hours switch on.
• Use the + (C6) or - (C3) buttons to set the number of hours
delay before the appliance turns o . A few second after set,
the setting is memorised, the timer symbol is lit and the
display shows the current mode.
At the end of the set time the appliance automatically turns
in standby mode.
To delete the setting, press two times the timer button (C4). The
timer symbol (C13) switches o .

OPERATING FROM THE REMOTE CONTROL

USING THE REMOTE CONTROL
• Point the remote control at the receiver (A11) on the air
conditioner. The remote control must be no more than 16
ft (5 meters) away from the appliance (without obstacles
between the remote control and the receiver).
• The remote control must be handled with extreme care. Do
not drop it or expose it to direct sunlight or sources of heat.
NOTE: The remote control can be safely stored in the appropiate
compartment A12 (see figure).
9
MAX 16 ft
MAX 5 meters