Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
Than you for choosing a De'Longhi product. Please ta e a few
moments to read the instructions to avoid ris s or damage to the
appliance.
DESCRIPTION
Description of the appliance (see page 3 - Fig. A)
A1 air outlet grille
A2 control panel
A3 handles
A4 castor wheels
A5 BioSilver filter
A6 air inta e grille
A7 air exhaust hose housing
A8 air inta e grille
A9 power cable
A10 drainage hose with cap
A11 remote control signal receiver
A12 remote control compartment
Description of the accessories (see page 3 - Fig. B)
B1 wall flange with cap
B2 assembled air exhaust hose
B3 window outlet
B4 window brac et with pins
B5 additional window brac et with pins
B6 water drain hose with cap
B7 remote control
B8 end of season dust cover
B9 end of season accessories bag
Electrical connection
Before plugging the appliance into the electrical receptacle,
chec that:
•
The outlet's power supply corresponds to the value indi-
cated on the rating label on the bac of the appliance;
•
The outlet and electrical circuit are adequate for the appli-
ance;
•
The outlet is a 3-hole grounded outlet
the case, you must choose another outlet. Failure to follow
these important safety instructions absolves the manufac-
turer of all liability.
If it becomes necessary, the power cable must be re-
placed by a quali ed professional only.
The instructions below will enable you to prepare your air con-
ditioner for operation as e ciently as possible. Before use, ma e
sure the air inta e and outlet grilles are unobstructed.
USE
AIR CONDITIONING WITHOUT INSTALLATION
For optimal results set-up in a double-hung window:
1) Place the brac et in the window sill, extend the brac et
fully within the window frame, fix the brac et by using the
pin then lower the window onto the brac et. (Should the
window brac et be too large for the window. The plastic
can be cut with a saw by a qualified professional.)
2) Fit the air exhaust hose B2 in the housing at the bac of the
appliance. Insert it as shown in figure 1.
1
3) Connect the window outlet B3 to the other end of the ex-
haust hose.
4) Insert the window outlet end of the exhaust hose into the
slot of the window brac et (fig. 2).
2
. If this is not
Other set-up methods:
•
Than s to the loc ing pins, it's possible to use the window
brac et also for sliding windows. Position the hole of the
brac et so to allow a correct installation of the exhaust hose
(see figure 3).
5
Tabla de contenido
