Air-Conditioning Without Installation; Other Set-Up Methods - DeLonghi PAC CN120E Instrucciones De Uso

• Fit the wall flange 11 into the hole.
Screw the hose adaptor 13 to the hose's end 12.
•
• Fit the air exhaust hose in the housing at the back of the
appliance as shown in figure A.
• Screw the wall mounting accessory 14 into the hose 12.
(fig. D) and fit it into the wall flange 11 as shown in fig. E.
D
E
When the hose 12 is not fitted, the hole can be closed with the
flange cap 11 .
NOTE: When air conditioning with installation, you should
leave a door slightly open (as little as 1 cm) to guarantee correct
ventilation.
KEEP THE AIR HOSES AS SHORT AND FREE OF CURVES AS
POSSIBLE TO AVOID CONSTRICTIONS.

AIR-CONDITIONING WITHOUT INSTALLATION

Just a few simple steps and your comfort is ensured with your
air conditioner:
Screw the hose adaptor 13 to the hose's end 12.
•
• Fit the air exhaust hose in the housing at the back of the
appliance. Insert it as shown in figure A.
•
2
Sash window
•
•
•
MAX100 cm
MAX 39 inches
•
•
MIN 35 cm
MIN 14 inches

Other set-up methods:

•
6
Preparing for use
Screw the window outlet 17 to the other end of the
exhaust hose. (see fig. F).
F
Open the window.
Place the window bracket 15 in the window, extending it
to fit the width of the window (fig. G).
Place the air conditioner near the window. Insert the
assembled exhaust hose 12 into the window bracket hole
15.
Make sure the air exhaust hose is unobstructed.
If you have a very large window, in order to cover your
window aperture, use the additional window bracket
without holes extending it to the desired dimension,
then fix the bracket by using the locking pin provided.
When extracting the window bracket and joining the two
pieces pay attention you do not cover the hole.
Thanks to the locking pin, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust
hose (see figure H).
en
G