Air Conditioning Without Installation - DeLonghi AN Serie Instrucciones De Uso

3
in the in the wooden
window kickboard of a
panel French window
Fit the wall ange B1 into the hole.
•
Screw the wall mounting accessory B4 into the hose B2
•
and t it into the wall ange B1 as shown in g. 4.
• Fit the end of the hose B2 to the wall ange B1 as shown in
g. 4.
• When the hose B2 is not connected, the drilled hole can be
closed with the ange cap B1.
4
NOTE:
• As special tools are required for installation, we sug-
gest you have the appliance installed by specialized
personnel.
• When installing the air conditioner, you should leave a door
slightly open little as 1/2" (1 cm) to guarantee correct
ventilation and room pressure.
• Keep the air hoses as short and free of curves as possible to
avoid constrictions.
in the wall:
you are
recommended to
insulate the section
of wall using suita-
ble insulation.
MAX 39 in
MIN 14 in
6

AIR CONDITIONING WITHOUT INSTALLATION

You can also set-up in a double-hung window:
• Place the window bracket in the window sill, extend the
bracket fully within the window frame, x the bracket by
using the pin then lower the window onto the bracket.
(Should the window bracket be too large for the window.
The plastic can be cut with a saw by a quali ed profes-
sional.)
• Screw the hose adaptor B3 to the hose's end B2.
• Fit the air exhaust hose B2 in the relevant housing located
on the rear side of the appliance. ( g. 1).
Connect the window outlet B7 to the other end of the ex-
•
haust hose.
• Insert the window outlet end of the exhaust hose into the
slot of the window bracket ( g. 5).
5
Other set-up methods:
• Thanks to the locking pins, it's possible to use the window
bracket also for sliding windows. Position the hole of the
bracket so to allow a correct installation of the exhaust hose
(see gure 6).
6
• If you have a casement window ( gure 7) proceed as fol-
lows:
• Screw the hose adaptor B3 to the hose's end B2.