Klarstein 10031436 Manual Del Usuario página 38

Step 3: Installing the Ceiling Assembly
Make sure that you have properly matched the roof top air conditioner and interior ceiling assembly.Caution
before tightening bolts:
• The applicable thickness of vehicle roof ranges from 30mm-80mm.
• Before tightening bolts, screw in the four bolts manually and prohibit screwing forcibly.
• When screwing bolts, you can use automatic tool. Do not tighten one bolt completely and then tighten
other bolts, in order to prevent sticking of screw thread.
• The max torque for tightening ranges from 2.3Nm-2.5Nm.
The following step by step instructions must be performed in the following sequence to ensure proper instal-
lation:
1. Carefully take the ceiling assembly out of the carton (The remote control packed with the ceiling assembly).
2. Remove the ceiling grille from the ceiling assembly.
3. Before the ceiling assembly can be mounted to the roof top air conditioner, the fabric duct collar must be
fastened to the base pan of the roof top air conditioner with 4 screws by upper duct plate.
4. Before lifting the ceiling assembly, pull the fabric duct collar so it hangs out of the way and does not get
caught under the ceiling assembly frame.
Thickness of vehicle roof:
Max 30-80mm
4 Bolts
Gasket
Fabric Duct Collar
38