Control Panel And Controls - Klarstein 10031436 Manual Del Usuario

Replacement of Batteries
Remove the battery cover plate from the rear of the remote controller. Take out the old batteries. Insert two
new AAA1.5V dry batteries, and pay attention to the polarity. Reinstall the battery cover plate.
• When replacing the batteries, do not use old or different types of batteries, otherwise, it may cause malfunction.
• If the remote controller will not be used for a long time, please remove batteries to prevent batteries from
leaking.
• The operation should be performed in its receiving range.
• It should be kept 1m away from the TV set or stereo sound sets.
• If the remote controller does not operate normally, please take the batteries out and reinsert them after 30
seconds.If it still can't operate properly, replace the batteries.
1 ON/OFF button
Operation starts when pressing this button, and
stops when pressing this button again.
2 SWING button
Activate the automatic air swing function.
3 FAN SPEED button
Select the fan speed LOW, MEO, HIGH and TURBO
in sequence.
4 (+/-) button
Press the+ button to increase the set temperature, press
the - button to decrease it. The temperature setting range is
from 16-30°C (61-86°F).

Control Panel and Controls

4 TIMER button
Press TIMER button, then press +/- to increase and decrease the
time setting. If the time setting is no more than 10 hours.the incre-
ment/decrement is 0. 5 hour by each press, if more than 10 hours,
the increment/decrement is 1 hour by each press. The time setting
range is 0. 5-24 hours.
5 MODE button
Select the operation mode, COOL, DRY, FAN, HEAT (for heat
pump model) or COOL, DRY, FAN (for cooling only model).
6 FILTER CHECK
The light turns on automatically after the fan works more than
250 hours. If the light is on, power off the unit, take the air filter,
clean and reinstall it. If the light still burns, press this button.
Not available for
cooling only model
34