Beuchat VRT 30 Manual De Instrucciones página 35

2 > MAINTENANCE
A > BEFORE THE DIVE :
Please note that the pr ocedures outlined below do not
apply to cold water regulators which requires specific pre-
paration and use.
• Remove the dust protector and install the first stage on
the valve by tightening the yoke scr ew or DIN kit (do not
over tighten).
• Open the valve completely and check the cylinder pr es-
sure on the pressure gauge.
• Purge the second stage by depressing the purge button
for a few seconds to ensure proper air delivery.
• Put the 2nd stage in Dive mode (Except VS)
Venturi + and Sens. Adjust. knob open
• Take several inhalations on the second stage while on
the surface before starting your dive.
B > AFTER THE DIVE :
• Close the cylinder completely (turn off the valve).
• Remove any residual air from the regulator by purging the
second stage (depress the purge button).
Presentation / User guide
• Remove the regulator by unscrewing the yoke DIN connector.
• After drying the dust cap, r eplace it over the yoke r etainer
(Do not blow high pressure air directly on the regulator filter to
prevent humidity from entering the high pressure chamber).
3 - CAUTION
• Do not leave your r egulator exposed to dir ect sunlight
when possible.
• Do not use the regulator first stage as a handle to carry
the cylinder.
• After every dive quickly r emove the regulator from the
cylinder to preserve it from any shock damage.
• In every case always handle your with car e.
A > CLEANING
After the dive your regulator should be cleaned with fresh
water. Before rinsing your first stage, make sur e the dust
cap is in place.
BEUCHAT recommends the use of cleaning/desinfection product
(cold process) for the destruction of the germs on r egulators.
> 33