Programming A Somfy Rts Gate Motorisation; Programming A Somfy Rts Lighting Receiver - SOMFY VSYSTEMPRO Manual De Instalación

6.4 Programming a Somfy RTS gate motorisation

[1]. Open the cover on the control cabinet or the motor containing the electronics.
[2]. Check that the motor is switched on.
[3]. Remove the monitor from its mounting bracket.
[4]. Select the desired channel by pressing the channel selection button on the monitor.
[5]. Place the monitor on the target on the motor electronic unit.
Important: The le -hand section of the monitor must be placed on the electronic unit target so that the monitor can be
correctly detected by the motor electronics.
[6]. Briefly press the monitor opening button.
- The RADIO indicator lights on the motor electronic unit lights up then goes out.
[4]
1..2..3..4..5
Note: To clear the video entry phone programming on a Somfy gate motorisation, see the motorisation guide.

6.5 Programming a Somfy RTS lighting receiver

On a Somfy RTS remote control terminal or socket
[1]. Check that the remote control socket/plug is switched on.
[2]. Select the channel by pressing the channel selection button on the monitor.
[3]. Press the programming button on the remote control socket/plug until the indicator light flashes.
[4]. Briefly press the PROG button at the back of the monitor (above the battery housing).
- The indicator light on the remote control socket/plug will come on permanently, then go off.
[2]
1..2..3..4..5
Examples of Somfy remote control sockets and plugs
Note: To clear the programming on the videophone on an RTS remote control socket or plug, repeat all the steps described
above.
Copyright © 2016 Somfy SAS. All rights reserved.
[5]
[3]
2s
2s
< 0,5s
[4]
2s
EN
11