Gewiss Chorus GW 10 763 Manual De Usuario página 60

INSTALLATION INSTRUCTIONS
The channels available in the programming mode are:
StS (Status)
Used to send to remote devices (for instance the EIB Easy
GSM remote control unit - GW 90 861):
• operation type and mode:
• temperature reading (every 15 minutes or each time it
changes).
The channel is indicated as "ClimStatus X.2" on the base unit.
CdH (Command Heating)
Used to send the ON/OFF command to the KNX/EIB
actuators that control the heating system.
The channel is indicated as "Cmd+info X.3" on the base
unit.
CdC (Command Cooling)
Used to send the ON/OFF command to the KNX/EIB
actuators that control the air conditioning system.
The channel is indicated as "Cmd+info X.4" on the base
unit.
Cd1 (Command 1 - Fan coil speed)
Used to send the ON/OFF command to the actuator
channel that controls speed 1 on the fan coil The channel
is indicated as "Cmd+info X.5" on the base unit.
Cd2 (Command 2 - Fan coil speed 2)
Used to send the ON/OFF command to the actuator
channel that controls speed 2 on the fan coil The channel
is indicated as "Cmd+info X.6" on the base unit.
Cd3 (Command 3 - Fan coil speed 3)
Used to send the ON/OFF command to the actuator
channel that controls speed 3 on the fan coil. The channel
is indicated as "Cmd+info X.7" on the base unit.
60