Gewiss CHORUS GW 16 974CB Manual De Programación página 69

USER INSTRUCTIONS
Setting the control modes
Press the button key to access value change; after the
access, the current parameter value is displayed. Change
the thermostat control mode (0 = stand alone; 1= slave)
using the circular touch slider or the push-button
parameter is visible only if the device is configured with
Easy Controller or if it has been set up as a slave via ETS.
To confirm the set value, press the
thirty seconds; expiry of the timeout (30 seconds) or
pressing the push-button
page without saving it.
Thermostat deactivation and switch-off
Press the button key to access value change; after the
access, the current parameter value is displayed. Change
the condition that allows the deactivation of thermostat
switch-off (0 = locally; 1 = remotely and/or locally) using
the circular slider touch or the push-button
parameter is visible only if the device is configured with
Easy Controller and if it has been set up as a slave or stand
alone with Setpoint control. To confirm the set value, press
the button key within thirty seconds; expiry of the
timeout (30 seconds) or pressing the push-button
in exiting the change page without saving it.
69
button key within
result in exiting the change
. The
E
N
G
L
I
S
H
. The
result