Tabla de contenido
Idiomas disponibles
Idiomas disponibles
(1)
The operating mode of the device (heating or cooling) can be managed manually or autonomously (by the
device itself). The manual method is via the local navigation menu or BUS commands that allow you to switch
from one type to another, modifying the specific parameter. The automatic mode is based on the principle of
an interdiction area - i.e. the temperature gap between the setpoints of the HVAC heating and cooling modes,
allowing the automatic switchover from one type of operation to the other.
OFF
Economy
(Building protection)
Interdiction area
USER INSTRUCTIONS
Heating/cooling selection
Press the
access, the current parameter value is displayed. Select the type
of operation (
using the circular touch slider or the push-button
"automatic" function is visible if the interdiction area
enabled via the relative ETS parameter. To confirm the set value,
press the
button key within thirty seconds; expiry of the
timeout (30 seconds) or pressing the push-
the change page without saving it.
Pre-comfort
Comfort
The figure shows that as long as the detected temperature
is below the heating set-point, the operating mode is
Air-cooling
"heating"; if the measured value is
higher than the cooling setpoint, then the operating mode
is cooling. If the detected value is within the interdiction
area, the operating mode remains as before. The heating
-> cooling switchover point corresponds to the setpoint of
the HVAC mode relating to cooling; The cooling -> heating
switchover point corresponds to the setpoint of the HVAC
mode relating to heating.
Heating
Setting the hour
Press the
access, adjust the current value using the circular touch
slider or the
To confirm the set value, press the
thirty seconds; expiry of the timeout (30 seconds) or
pressing the push-button
page without saving it.
53
button key to access value change; after the
= heating;
= cooling;
button key to access value change; after
push-button.
result in exiting the change
= automatic)
. The
has been
(1)
result in exiting
button key within
E
N
G
L
I
S
H
Capítulos
Tabla de contenido
