Pages relating to the thermostat (control type: set-point)
Pages relating to the thermostat (control type: HVAC or set-point)
USER INSTRUCTIONS
Forcing the set-point manually
If the type of control set is setpoint, by acting on the circular
touch slider it is possible to temporarily force the
aforementioned setpoint (within the limits of the regulation
interval imposed by ETS).
The forcing remains active until the operating set-point is
modified, or until the thermostat is manually switched off.
Manual switch-off
If the type of control set is setpoint, press
manually switch off the device (
Press the
button key again to reactivate the device;
when the button key is pressed, the active set-point will be
shown for a few moments. If configured with Easy Controller,
the operation is always possible, whereas it must be
authorised with ETS.
Choosing the fan coil speed
If any mode other than OFF is active or the operation setpoint
is active, press the
to access the selection page (the control algorithm
for heating/cooling operation must be set to fan coil).
Use the circular touch slider or the push-button
the
desired
or
key
; the expiry of the timeout of 30 seconds or pressing
any other push-button results in leaving the selection page
without saving the setting.
49
).
button key for at least 3 seconds
fan
coil
setting
) and then reconfirm with the button
E
N
button key to
G
L
I
S
H
to select
(
,
,