Assembly - Hanging the Fan (continued)
3
Setting the code on the remote
control and receiver
NOTE: The frequencies on your receiver and remote
control have been preset at the factory. Before installing
the receiver, make sure the dip switches on the receiver
and remote control are set to the same frequency. The dip
switches on the remote control are located inside the battery
compartment.
NOTE: The battery will weaken with age and should be
replaced before leaking takes place as this will damage the
remote control. Dispose of used battery properly and keep
the battery out of the reach of children.
□
Remove the remote control (K) battery cover by pressing
firmly on the arrow and sliding the cover off.
□
Slide the dip switches to your choice of either up or down.
The factory setting is up.
□
Slide the dip switches (LL) on the receiver (J) to the same
position as set on the remote control (K).
□
Replace the battery cover on the remote control (K).
K
ON
DIP
1 2 3 4
LL
J
4
Installing the receiver
WARNING: To reduce the risk of fire or electric shock,
remember to disconnect power. The electrical wiring must
meet all local and national electrical code requirements.
The electrical source and fan must be 110/120 volt, 60Hz.
Do not use this product in conjunction with any variable wall
control. Incorrect wire connection can damage this receiver.
CAUTION: If other fan wires are a different color, have this
unit installed by a licensed electrician.
CAUTION: Do not install the receiver in a damp location or
immerse in water (For indoor use only). Do not pull on or cut
the receiver leads shorter. Do not drop or bump the unit.
□
Position the house supply wires (AAA) to one side of the
slide-on mounting bracket (A); position the fan wires (BBB)
to the opposite side.
□
Insert the narrow end of the receiver (as shown, flat side
towards the ceiling) into the slide-on mounting bracket until
it rests on top of the ball/downrod assembly.
A
9
Please contact 1-855-HD-HAMPTON for further assistance.
J
BBB
AAA
C
B
HAMPTONBAY.COM