14.2 Delivery scope and transport inspection
As a rule, the Master E2 is delivered with the following components:
Induction cooker with 2 hobs for assembly
4 brackets and 4 screws for assembly
Operating Instructions
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
14.3 Unpacking
To unpack the device, remove the device out of the carton and remove the packaging
material.
14.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and reduces the
quantities of accumulated waste. Take any packaging materials that are no longer required
to "Green Dot" recycling collection points for disposal.
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
14.5 Setup
14.5.1
Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:
The appliance is designated for assembly.
The wall and induced heating zone above the table surface shall withstand heat. The
safety distance between the hotplate and cupboard above should be at least 760 mm.
The appliance must be positioned on a solid, even, horizontal and heat-resistant base
with sufficient load-supporting capacity for the appliance itself plus the heaviest
anticipated cooking contents. The thickness of the table surface is at least 30 mm.
Please note
Please note
41