Installation Instructions; Preparing For Installation; Installing The Holder - Truma AquaGo comfort Manual Del Usuario

Installation instructions

You will find more information about the
following in the operating instructions for
the Truma AquaGo™ instant water heater:
• Operation
• Access door
• Draining the water

Preparing for installation

1. Remove the access door.
2. Switch OFF the Truma AquaGo™ instant
water heater at the POWER switch and at the
control panel (set Operating mode to OFF).

Installing the holder

3. Attach the holder to the rear side of the ac-
cess door, as shown in Figure 2.
• Undo the two screws of the webbing
about 1/10 inch (2.5 mm).
• Position the holder below the screws.
• Tighten the screws.
Holder
Fig. 2
Webbing
Screws
Holder
Access
door
5