CLIPIC MECHA Manual Del Usuario página 97

Major components
1. Pull back the rubber dust cover (2).
2. Looen the lock nut (3) and turn the adjuster (4). Tigthen
the lock nut (3) and check the adjustment.
3. If the adjuster is threaded out near its limit or if the correct
free play cannot be obtained, loosen the lock nut (3) and turn
in the cable adjuster (4) completely. Tighten the lock nut (3)
and install the dust cover.
4. Loosen the lock nut (6) at the lower end of the cable. Turn
the adjusting nut (5) to obtain the specified free play. Tighten
the lock nut (6) and check the adjustment.
5. Start the engine, pull in the clutch lever and shift into gear.
Make sure the engine does not stall and the motorcycle does
not creep.
Gradually release the clutch lever and open the throttle. The
motorcycle should begin to move smoothly and accelerate
gradually.
If proper adjustment cannot be obtained or the clutch does
not work correctly, see your CLIPIC dealer.
97
2. Dust cover
3. Lock nut
4. Clutch cable adjuster
A. Decrease free play
B. Increase free play
5. Adjusting nut
6. Lock nut
A. Decrease free play
B. Increase free play