CLIPIC MECHA Manual Del Usuario página 129

Maintenance
5. Discard the spark plug if there in apparent wear or if the
insulator is cracked or chipped.
6. Check the spark plug gap(l)using a wire-type feeler gauge,
if adjustment is necessary, bend the side electrode (2) care-
fully.
The gap should be:
0.6-0.7mm(0.02-0.03in)
7. Make sure the plug washer is in good condition.
8. Wth the plug washer attached, thread the spark plug in by
hand to prevent cross-threading.
9. Tighten a new spark plugl/2tum with a spark plug wrench
to compress the washer. If you are reusing a plug, it should
only take 1/8-1/4 turn after the plug seats.
NOTICE
The spark plug must be securely tightened. An impro-
perly tightened plug can become very hot and possibly
damage the engine.
10. Reinstall the spark plug cap.
129
1. Spark plug gap
2. Side electrode