Daily Cleaning - Beko CEP5152B Manual Del Usuario

6 Cleaning and Maintaining Your Machine

6.1 Daily Cleaning

1. Always make sure the Control Knob (5) is in the
" " position and the machine is powered
off by pressing the Power Button (11) on the
side of the machine so that the blue light is
turned off. Unplug the cord from the outlet and
allow all of the parts to cool before cleaning.
2. Remove and wash the frothing sleeve (12) and
wipe the frothing wand (10) with a damp cloth.
3. The water tank (3), sieves and drip tray (9) can
be washed in a solution of hot water and mild
liquid soap.
A
CAUTION: Do not immerse appli-
ance in water, in any other liquid or
place in the dishwasher.
C
Never use abrasive cleansers, steel
wool pads or other abrasive materi-
als to clean the machine.
6.2 Cleaning the Frothing
Wand
It is recommended to purge (chapter 6, point
3) and wipe the frothing wand (10) clean with
a damp cloth each and every time immediately
after frothing or steaming milk to prevent build
up. Thoroughly clean the frothing wand before
turning off the machine to ensure cleanliness.
1. Pull the black frothing sleeve (12) down and off
the frothing wand (10) and clean under warm
running water.
2. Fill a cup with a bit of water and immerse the
frothing wand (10).
3. Turn the Control Knob (5) to the right towards
the "Steam icon" and let steam push into the
water for a few seconds.
4. Turn the Control Knob (5) back towards the
center to the OFF position "
18 / EN
5. Use a cloth to dry the frothing wand (10) and
replace the black frothing sleeve (12), ensuring
it is firmly pushed up onto the frothing wand.
6. If extremely clogged, the frothing tip can be
unscrewed, and soaked in warm soapy water
for approximately 30 minutes. Once soaking
is complete, thoroughly rinse the tip under
running water.
A
C
C
".
Manual Espresso Machine / User Manual
CAUTION: The frothing wand
(10), frothing tip, and frothing
sleeve (12) may be VERY HOT!
To avoid potential injury, always
make sure that all parts have cooled
down completely before handling.
If no steam comes out of the froth-
ing wand (10), hardened milk blocks
its path. Turn the Control Knob (5)
back to the "
Remove the black frothing sleeve
(12) and carefully use a needle to
loosen the milk residue from the
opening of the frothing tip to re-
move any blockage, then steam
again.
In order for your machine to work
properly time after time, clean the
frothing wand (10), sleeve and tip
after each use as described above.
" position.