Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Pulse Assist Mode
WARNING: Do not work for long periods with the Pulse Assist Mode
activated as the motor can be overheated.
NOTE: Pulse Assist Mode is very effective to prevent stripping screws, removing
stubborn screws and to prevent the bit tip from walking when drilling on smooth
surfaces. When the Pulse Assist Mode is activated, it can be switched with the
drill/drive mode.
• Make sure the Forward/Reverse Rotation Switch (4) is pushed to the left or right
and the Pulse Assist Mode is selected.
• Press the Variable Speed Switch (9), the tool will begin to rotate at a controllable
pace.
Variable Speed Switch
WARNING: Do not operate for long periods at low speed because excess
heat will be produced internally.
Using the LED light
To turn on the light, press the Variable Speed Switch (9) and make sure the
Forward/Reverse Rotation Switch (4) is on right or left position. When you release
the Variable Speed Switch (9), the light will go off after a moment.
The LED Light is also a battery capacity indicator. It will flash when power gets
low.
The tool and battery pack are equipped with a protection system. When the LED
Light is quickly flashing, the system will automatically cut power to the tool to
extend battery life. The tool will automatically stop during operation if the tool
and/or battery pack are placed under one of the following conditions:
12
• Overloaded: The tool is operated in a manner that causes it to draw an
abnormally high current. In this situation, release the Variable Speed Switch on
the tool and stop the application that caused the tool to become overloaded. Then
pull the Variable Speed Switch again to restart.
• Overheated: Under the condition above, if the tool does not start, the tool and
Battery Pack are overheated. Let the tool and Battery Pack cool before pulling the
Variable Speed Switch again.
• Low battery voltage: The remaining Battery capacity is too low and the tool
will not operate. Remove and recharge the Battery Pack.
Drill / Driver
See Fig. F
See Fig. G
See Fig. G
EN
Tabla de contenido
