Prior Information; Field Of Application; Liability; Installation - SOMFY Zigbee Sonesse 28 WF Manual De Instrucciones

Sonesse 28 WF Zigbee

1.PRIOR INFORMATION

1.1.Field of application

The Sonesse 28 drives are designed to motorise all types of:
▪ Interior vertical blinds which front rail moves solely by gravity with a mass less than 15 kg.

1.2.Liability

Before installing and using the drive, please read these instructions carefully.
In addition to the instructions provided in this guide, please also comply with the instructions provided in the attached Safety
instructions document.
The drive must be installed by a home motorisation and automation professional, in accordance with Somfy's
instructions and the applicable regulations in the country of installation.
Any operation of the drive outside the field of application described above is prohibited. Such use, and any failure to comply
with the instructions given in this guide and in the attached Safety instructions document, absolves Somfy of any liability and
invalidates the warranty.
After installing the drive, the installer must inform his customers of the operating and maintenance conditions for the drive
and must provide them with the operating and maintenance instructions, and the attached Safety instructions document.
Any After-Sales Service operation on the drive must be performed by a home motorisation and automation professional.
Never begin installing without first checking the compatibility of this product with the associated equipment and
accessories. If in doubt when installing this product and/or to obtain additional information, contact a Somfy representative
or visit the website www.somfy.com.
Using this drive with any products which are not listed in the attached «Compatibility matrix» document shall also
render invalid any Somfy warranty and release Somfy from any liability.

2.INSTALLATION

CAUTION
• These instructions are mandatory for the home motorisation and automation professional installing the drive.
• Never drop, knock or puncture the drive or immerse it in liquid.
• Install an individual control point for each drive.
NOTICE
Make sure that LED, programming button and input connection remain visible and easily accessible after installation.

2.1.Assembly

2.1.1.Preparing the drive

CAUTION
Sonesse 28 Zigbee : interior diameter of the tube has to be Ø26.6 mm or greater.
1] Fit the crown (a) and drive wheel (b) to the motor.
2] Measure the length (L) between the end of the drive wheel and the head end.

2.1.2.Preparing the tube

1] Cut the tube to the required length.
2] Deburr the tube and remove the debris.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
1] 2]
EN
(a)(b)
3