Finding Interference Frequencies - AKG WMS 4000 Modo De Empleo

• Repeat the two steps above to change all characters as desired.
3. Save or delete the name
• Press the SETUP control briefly. The display will change as follows:
• To save your setting, press the SETUP control briefly. The display will revert to the NAME screen.
• If you'd rather not save your setting, turn the SETUP control CW. The display will change as follows:
- To delete the current name, turn the SETUP control CW again. This will display the following option:
• Press the SETUP control briefly. The display will revert to the NAME screen.
The Environment Scan function automatically searches the receiver's entire frequency band from Start to
Stop (see Frequency Tables on page 122) for interference frequencies. During the search, the audio out-
put is muted and the display indicates the frequencies in MHz as they are scanned.
The frequency spacing for the automatic scan is 100 kHz. Frequencies whose field strength exceeds the
factory-set threshold (or the threshold you may have set using the Threshold function in the EXTRA menu)
are defined as interference frequencies and saved in a scan list.
The receiver can store a maximum of eight interference frequencies. As soon as the Stop frequency is
reached or the scan list is full, the scan will be stopped automatically.
Venues that are extremely hostile to RF transmission may make it necessary to change the Environment
Scan threshold setting. You can change the setting using the THRESH function in the EXTRA menu.
1. In SETUP mode, turn the SETUP control CW or CCW to call up this screen:
2. Press the SETUP control briefly. The display will change as follows:
3. To start the scan, press the SETUP control briefly. The scan will start and the display will show the fre-
quencies as they are scanned:
3 Setting Up
3.8.6 Finding Interference
Frequencies
Note:
33