Tabla de contenido
Idiomas disponibles
Idiomas disponibles
K-5208 Drain Cleaning Machine
Preparing For Transport
Remove the guide hose from the machine. Latch the
clutch lever handle in the down position. Wrap cord around
the clutch lever handle and clip the GFCI in place. Secure
as shown in Figure 15. Firmly insert Decoupler in holder to
secure. When loading cable sections into a cable carrier,
connecting the sections makes loading and unloading
easier. One transport method shown in Figure 16.
Figure 15 – Cord In Transport Position
Figure 16 – Transport
14
Storage
The drain cleaner must be kept dry and in-
WARNING
doors or well covered if kept outdoors. Store the ma-
chine in a locked area that is out of reach of children
and people unfamiliar with drain cleaners. This machine
can cause serious injury in the hands of untrained users.
Maintenance Instructions
WARNING
FOR/O-OFF/REV switch should be O-OFF and ma-
chine unplugged before performing any mainte-
nance. Always wear safety glasses and other
appropriate protective equipment when perform-
ing any maintenance.
Cleaning
A mild detergent or antibacterial solution can be used if
desired. Do not use solvents, abrasives or other harsh
cleaning agents.
Machine – Use a damp, soft cloth to wipe off the ma-
chine. Do not submerge or flush the machine with water.
Do not allow water to enter motor or other electrical
components. Make sure unit is completely dry before
plugging in and using.
Monthly, follow the "Changing Clutch Jaw Assembly" di-
rections and inspect the clutch jaws. Clean or replace if
necessary.
Cables– Remove debris from cable and flush cable with
water after every use to prevent damaging effects of sed-
iment and drain cleaning compounds. Allow to dry to re-
duce cable corrosion.
Guide Hose – Flush with water and drain. Use a damp,
soft cloth to wipe off. Allow to dry to reduce corrosion.
Lubrication
Machine – machine is lubricated for life and requires no fur-
ther lubrication.
Cables – lubricate coupling plunger pins with light ma-
chine oil.
Guide Hose – Pull a lightly oiled towel through the dry guide
hose to keep it flexible.
Jaw/Clutch Adjustment
When clutch lever handle is in up position (released), if the
cable will not slide through the machine, the jaws are
set too small. If the cable does not turn when the clutch
lever handle is engaged, the jaws are set too large.
When changing between 1
cable, the clutch must be adjusted.
1. Open quick release on collar (Figure 17).
1
/
" (32mm) and
7
/
" (22mm)
4
8
999-995-137.10_REV. B
Capítulos
Tabla de contenido
Solución de problemas
