Connecting The Receiver To The Mains Power Supply; Checking The Direction Of Rotation Of The Motor And Adjustment Of The Motor End Limits - SOMFY Home Motion ROLLIXO RTS Manual De Instalación

Rollixo RTS
> fall protection wiring
The fall protection device must be wired.

3.3 Connecting the receiver to the mains power supply

[1]. Fully unfold the receiver aerial so that it is pointing downwards.
[2]. Screw the bulb supplied into the receiver.
A bulb of the same type as that supplied (E14 - 15W max - 230V)
must be used. Using another type of bulb may cause overheating.
[3]. Replace and screw in the receiver cover.
[4]. Refit the integrated lighting bulb.
[5]. Connect the receiver to the mains power supply .
All the indicator lights come on and then go out.
If indicator light 1 comes on permanently, fall protection is not connected
or incorrectly connected to the receiver.
If indicator light 2 comes on permanently, the safety edge has not been
detected by the receiver (radio safety edge transmitter not yet memorised
or the wired safety edge is still not connected).
[1]
[3]
[5]
Copyright © 2014 Somfy SAS. All rights reserved.
Stop Safety Edge K
Sec
5 6 7 8 9 1
[2]
[4]
1 2 3 4
STOP Prog
3.4 Checking the direction of rotation of the motor and
adjustment of the motor end limits
[1]. Press simultaneously on the
down movement occurs to enter motor adjustment mode.
Indicator light 1 flashes slowly.
1 2 3
STOP
[2]. Press button
or to check the motor's direction of rotation.
- If the motor's direction of rotation is correct, move on to step [3] of the
motor end limit setting procedure.
- If the direction of rotation is incorrect, press button
up and down movement occurs, check the motor's direction of rotation
again and move on to step [3] of the motor end limit setting procedure.
1 2 3 4
STOP
Correct direction of incorrect direction
rotation of rotation
step [3]
[3]. If the motor end limits are already set, move on to step [8] to exit motor
adjustment mode.
If the motor end limits are not set, check that the motor is released: the two
push-buttons should be pressed.
on
Note: The motor end limits can also be set with a setting tool (ref.
9015971). In this case, set the motor end limits with the cable then
move on to step [8] to exit motor adjustment mode.
[4]. Press button to position the garage door in the upper position.
Adjust the top position with buttons
1 2 3 4
STOP Prog
and buttons until the motor's up and
4
Prog
until the motor's
STOP
Prog
1 2 3 4
Prog
STOP
and .
5