Storing The Remote Controls; Memorising 2 Or 4-Button Remote Controls; Memorising 3-Button Remote Controls; Memorising By Copying A Previously Memorised Remote Control - SOMFY Home Motion ROLLIXO RTS Manual De Instalación

Rollixo RTS

10 - storinG the reMote ControLs

10.1 Memorising 2 or 4-button remote controls

[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press a button on the remote control to be memorised within a maximum
time delay of 2 minutes.
The indicator light above button
control is memorised in the receiver.
[1]
Prog
Prog

10.2 Memorising 3-button remote controls

[1]. Press the
button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the PROG button on the back of the remote control to be memorised
within a maximum of 2 minutes.
The indicator light above button
control is memorised in the receiver.
[1]
Prog
Prog
10.3 Memorising by copying a previously memorised
remote control
This operation must be carried out close to the receiver.
a = "source" remote control already stored
B = "target" remote control to be stored
> With an rts Keygo
A
> With a 3-button remote control
A
2s
12
on the receiver flashes; the remote
Prog
[2]
Prog
on the receiver flashes; the remote
Prog
[2]
Prog
A
B
2s
B
< 1s
11 - MeMorisinG safety eDGe
transMitters
Memorising a new radio safety edge transmitter overwrites the previous
transmitter.

11.1 storing an Xse or ose transmitter

[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Using the tip of a pen, press the transmitter PROG push-button for 4
seconds.
Indicator light 2 on the receiver goes out and the receiver Prog
indicator light will flash and then go out (this may take a few seconds,
the time required for the transmitter and receiver to communicate with
each other).
The transmitter is memorised in the receiver.
[1]
1 2 3 4
Prog
STOP
[2]
4 s
1 2 3 4
Prog
STOP

11.2 storing an ese transmitter

The transmitter must already be installed and the resistive safety
edge must be connected to the transmitter.
[1]. Press the button on the receiver until the indicator light comes on
Prog
permanently.
[2]. Press the button on the back of the safety edge transmitter 5 times.
The safety edge transmitter indicator light comes on with each press and
after the 5th press remains constantly lit for 4 seconds and then flashes
for 4 seconds.
Indicator light 2 on the receiver goes out and the receiver Prog
indicator light will flash and then go out (this may take a few seconds,
the time required for the transmitter and receiver to communicate with
each other).
The transmitter is memorised in the receiver.
[3]. Restart the magnet recognition procedure (see section 6.3).
[1]
1 2 3 4
Prog
STOP
[2]
x5
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
1 2 3 4
STOP Prog
1 2 3 4
Prog
STOP
safety edge
1 2 3 4
STOP Prog
Copyright © 2014 Somfy SAS. All rights reserved.