Recognising Magnets; Checking Operation Of The Receiver; Operation In Sequential Mode; Integrated Lighting - SOMFY Home Motion ROLLIXO RTS Manual De Instalación

Rollixo RTS

6.3 recognising magnets

It is essential that the following procedure is observed to ensure
completely safe operation of the door.
The door must be in the intermediate position before the magnet
recognition procedure can be started.
Do not press the safety edge during the magnet recognition
procedure.
Carry out two whole cycles (opening then closing) using buttons
1 2 3 4
STOP Prog
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
1 2 3 4
Prog
STOP
7 - CheCKinG oPeration of the
reCeiver
At the end of installation, it must be checked that the limitation of
forces complies with appendix A of the standard EN 12 453.

7.1 operation in sequential mode

STOP

7.2 integrated lighting

The lamp comes on each time a command is sent to the receiver.
It goes out 2 minutes after the door stops.

7.3 orange light

The orange light flashes every time the receiver is controlled, with or without a
2-second warning, depending on the configured parameter setting.
It stops flashing when the door stops.

7.4 Cells

If the cells are blocked when the door is closed, it stops, then re-opens fully.
If the cells are blocked when the door is opened, the door continues its
movement.
8
and .
STOP
STOP

7.5 safety edge

If the safety edge is activated when the door is closing, it stops then re-opens
partially.
If the safety edge is activated while the door is opening, it continues its
movement.

7.6 alarm (optional)

The alarm is triggered for 2 minutes if the door is fully closed and raised
manually. No movement of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it.
The alarm can only be stopped with a memorised remote control.

8 - ConneCtinG aDDitionaL DeviCes

8.1 General wiring diagram

Stop Safety Edge
M
Sec
L1 N L2 1 2 3 4
5 6 7 8
R
type of
terminal Connection
terminal
1 Earth RDO CSI 50 or 60
motor
2 L1
3 Neutral
4 L2
5 Contact Fall protection - NC
contact
6 Shared
7 Contact Safety edge safety
input
8 12 Vdc 12 Vdc safety edge
power supply
9 0 Vdc
10 Contact NO contact
11 Shared
12 24 Vdc 24V - 3.5 W orange
light output
13 0 Vdc
14 24 Vdc TX cell 24 V power
supply
15 0 Vdc
16 24 Vdc RX cell 24 V power
supply
17 0 Vdc
18 Shared
19 Contact Cell safety input (NC)
20 Test output Cell safety test output Reflex photocell self-test
22 433.42 MHz aerial
KeySwitch 24V Cell Sec Cell Test
Flash 24V dc
Sec
9 10 11 12 13 14 15 16 17 18 19 20
24 vdc
24 Vdc
aerial
Comments
Wired 8k2 resistive safety
edge (terminals 7 - 8)
Wired optical safety edge
(terminals 7 - 8 - 9)
Sequential control
Maximum 4 W bulb
Transmitting photoelectric
cell/Reflex photocell
power supply
Receiving photoelectric
cell power supply
Do not connect an offset
aerial (incompatible)
Copyright © 2014 Somfy SAS. All rights reserved.
Ant
22
Antenne