Tool Holder, Attachments; Working With The Electric Power Tool - Festool TPC 18/4 Manual De Instrucciones Original

English
Marking shows lighting duration on/
maximum torque. Briefly apply pressure
on the on/off switch [1-5] to permanently
switch the LED light on. After ten minutes, the
LED light automatically switches off.
Marking shows lighting duration off/
maximum torque. The LED light is perma­
nently switched off.
8.5 Impact drilling
Move the selector switch [1-8] to the hammer
. Set the thumbwheel [1-12] to the
symbol
drill symbol .
8.6 Festool Work app
The power tool can be configured with the
Festool Work app.
The battery pack is connected via
Bluetooth , see the operating manual for
®
the battery pack.
9

Tool holder, attachments

WARNING
Risk of injury
► Remove the battery pack from the power
tool before performing any work on the
power tool.
CAUTION
Risk of injury from hot and sharp insertion
tool
► Do not use any blunt or faulty insertion
tools.
► Wear protective gloves when handling an
insertion tool.
Prior to initial use: Apply some multipur­
pose grease to the drill spindle.
9.1 CENTROTEC tool chuck [7]
Fast changeover of tools with CENTROTEC
shaft.
WARNING! Only clamp CENTROTEC tools in
CENTROTEC tool chucks.
Wear gloves when replacing tools.
9.2 Chuck [8]
For clamping drill bits and bits with max. shaft
diameter of 13 mm.
WARNING! Clamp the tool centrally in the
chuck.
18
9.3 Angle attachment [9]
Drilling and screwdriving at right angles to the
power tool (available as an accessory depend­
ing on the model).
9.4 Tool holder in the drill spindle [10]
Bits can be inserted directly into the hexagon
socket holder of the drill spindle.
9.5 Eccentric adapter [11]
Screwdriving close to edges with bits according
to ISO 1173 (available as an accessory depend­
ing on the model).
9.6 Depth stop [12]
The depth stop (available as an accessory de­
pending on the model) allows a screw to be
tightened with a defined depth. You can set the
dimension to which the screwhead is to project
over the workpiece surface, or to which it is to
be inserted.
Depth adjustment
Firmly set the required screw-
in depth by turning the hous­
ing [12-1]. Each catch alters
the screw-in depth by 0.1 mm.
To unscrew a screw, the A/B sleeve must first
be removed.
10 Working with the electric
power tool
WARNING
Risk of injury
► Only position the power tool on the screw
when it is switched off.
► Always secure the workpiece in such a
manner that it cannot move during ma­
chining.
► Keep hands away from the rotating tools.
CAUTION
Risk of burns
The tool holder and tool may become very
hot during operation.
► Allow them to cool down before attaching
them to the belt clip.