Friedrich SQ06 Manual De Instalación Y Funcionamiento página 11

SETTINGS & ALERTS
ºF - ºC Select
To switch from degrees Fahrenheit (F) to Celsius (C), press
buttons simultaneously for three seconds.
An "F" will flash for 5 seconds. To change from F to C (or C back to F),
press the or button within those 5 seconds. After the 5 flashing
seconds of your desired setting (F or C), the display will revert back to
normal with your desired setting.
DIM Function
There are three separate display brightness levels, AUTO, 20% and full
(100%). To change the DIM setting, press the Power button for 3 seconds.
The 1 (shown below) indicates a DIM setting of Auto (factory default). Use
the or buttons to change the setting.
The 2 (not shown, but same placement as "1" above") indicates a DIM
setting of 20%. Press the TIMER SET (Figure 7) button within 15 seconds
to save the setting. Button inactivity for more than 15 seconds causes the
display to time out and return to the normal operating display.
The 3 (not shown, but same placement as "1" above") indicates a
DIM setting of 100% (full brightness). Press the TIMER SET button
within 15 seconds to save the setting. Button inactivity for more than
15 seconds causes the display to time out and return to the normal
operating display.
and
f
FRR133
1
FRR192
Check Filter Alert
When the filter needs to be cleaned or replaced, the
AUTO FAN
The alert can be dismissed by pressing the
Compressor Lockout Alert
The wait icon illuminates when the compressor lockout is active.
This feature reduces wear and tear on your unit by giving the
compressor adequate time to equalize pressure and prevents
damage that could occur from starting up the unit too quickly after
it stops running.
AUTO FAN
Compressor lockout typically lasts between 2 - 3 minutes. Once
wait icon clears, normal operation should begin.
Lock Control Panel
To lock the front panel controls, press and hold the
for 3 seconds. The lock icon
AUTO FAN
To unlock, press and hold the
FAN
SPEED
The lock icon disappears to indicate unlocked status.
icon displays.
CHECK
FILTER
79
F
SET POINT
CHECK
FILTER
and for 3 seconds.
FAN
MODE
79
F
SET POINT
+
FAN
SPEED
illuminates to indicate the locked status.
79
F
SET POINT
+ buttons for 3 seconds.
FRR118
FRR120
buttons
FRR116
11