Automatic Component Protection; Using The Remote Control - Friedrich WS08 Manual De Instalación Y Funcionamiento

Digital Control Panels
PM
Fan
Speed Mode
Timer Set
On/Off Hour
Figure 1:
WS Model cool-only control panel
PM
2 3 4
8
Fan
Smart
9
Mode
Speed
Fan
Money Timer
14
Saver On/Off Hour
13
10 11 12
Figure 2:
WY/WE Model heat-cool control panel

Automatic component protection

Your unit is equipped with Automatic Component Protection.
To protect the compressor of the unit, there is a three minute delay
if you turn the unit off or if power is interrupted. The fan will not be
affected. Also, if you switch from Heat/Cool mode to Fan Only mode, and
switch back to Heat/Cool mode, there is a three-minute delay before the
compressor comes back on.
Power
Cool
Money Saver ®
Fan Only
Clock
Start Time
Stop Time
Temp/Hour
Power
Cool
Fan Only
Heat
Clock
Set
Start Time
Stop Time
Temp/Hour

Using the remote control

To start unit (See Figure 3, page 6)
1 POWER - Press the Power button once. The unit will automatically
start in the mode and fan speed it was last left on.
To set mode of operation
2 COOL - Press the Cool button to automatically switch the operat-
ing mode to COOL.
3 FAN ONLY - Press the Fan Only button if you want to run the
fan only.
4 HEAT (WY/WE models only) - Press the Heat button to
automatically switch the operating mode to HEAT.
5 MoneySaver
the MoneySaver
compressor so that the fan does not run all the time.
To adjust temperature
6 WARMER - Press the
setting.
7 COOLER - Press the
setting.
1 To adjust fan speed
8 FAN SPEED - Press the Fan Speed button to see the current
setting. Press again to change the fan speed. F1 is the lowest
6
setting (SLEEP / LOW), F2 is MEDIUM, F3 is HIGH, and SF is
7
the SMART FAN setting.
5
To set the hour clock
9 SET HOUR CLOCK - Press the Set Hour . button once to see the
current clock setting. Continue pressing the button until you
arrive at the current time (Hour only). Minutes are not shown on
the display. Make sure that the A.M. / P.M. setting is correct.
- Press the Money Saver
®
feature. This feature cycles the fan with the
®
Warmer button to raise the temperature
Cooler button to lower the temperature
button to activate
®
5