Ingersoll Rand 551SMA–EU Instrucciones página 2

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
OILER ADJUSTMENT
To adjust oiler, remove the Backhead and turn the Oiler
Adjusting Screws. Turning the Screws in (clockwise)
decreases the oil flow. Backing the Screws out
(counterclockwise) increases the oil flow.
After adjustment, be sure the screw is at least 1/32"
(0.8 mm) below the Backhead face; otherwise, it will
prevent the proper seating of the Backhead on the Rear
End Plate.
FORWARD/REVERSE OPERATION
Models 551SMA–EU and 551S0A–EU Drills are capable
of operating in a Forward/Reverse or Forward Only mode
of operation. Make the mode selection prior to starting the
tool. Look at the arrows on the Throttle Sleeve. These
arrows indicate the direction in which the Throttle Sleeve
must be rotated to activate either forward or reverse
rotation of the Drill.
WARNING LABEL IDENTIFICATION
Always wear hearing
protection when operating
this tool.
Do not carry the tool by
the hose.
90 psig
(6.2bar/620kPa)
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
ADJUSTMENTS
WARNING
WARNING
WARNING
Hold the Drill in the normal operating position with the
Throttle Sleeve pointing towards the operator's right hand.
With the Throttle Sleeve in the operator's right hand, pivot
the Reverse Stop Lever away from the operator. With the
Reverse Stop Lever in this position, the Drill can be
operated in either the forward (clockwise) rotation mode or
reverse (counterclockwise) rotation mode.
Inadvertent movement of the Throttle Sleeve could
cause a sudden change in the direction of rotation of the
Drill.
Pivoting the Reverse Stop Lever toward the operator
prevents the reverse rotation of the Drill and permits the
Drill to be operated in the forward rotation mode only.
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________