Troubleshooting - Black and Decker ASI300 Manual De Instrucciones

Inflador de estación de aire

Ocultar thumbs Ver también para ASI300:

Manual de instrucciones (15 páginas)

Contenido

Tabla de contenido

Idiomas disponibles

494852-00 AS1300 inflator etc

SWITCH

The ON / OFF switch is located at the rear of the inflator just below

the storage compartment in the cavity that acts as a carrying

handle.

120v AC Mode

• Always fully extend the 120v AC cord before each use.

• To turn the inflator on, plug in the 120 volt cord and press the top

part of the switch marked "AC" (figure D).

• To turn the inflator off, partially depress the bottom part of the

switch marked "DC" to the "0" position.

12v DC Mode

WARNING! RISK OF UNSAFE OPERATION:

• Do not operate inflator when car engine is running.

• Always fully extend the 12v dc cord before each use.

• To turn the inflator on, plug the 12 volt adaptor into your vehicle's 12

volt accessory socket and press the bottom part of the switch

marked "DC" (figure D).

• To turn the inflator off, partially depress the top part of the switch

marked "AC" to the "0" position.

HOSE AND CORD STORAGE

The hose and cords are stored in the storage compartment on top

of the Inflator. The holes in both sides of the cover allow for the hose

and cord to be out of the compartment so that the compartment

cover can be closed while the Inflator is in use. (figure E)

MAINTENANCE

Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the

tool; never immerse any part of the tool into a liquid.

IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and

adjustment (other than those listed in this manual) should be performed by authorized

service centers or other qualified service personnel, always using identical replacement

parts.

Problem

• Unit will not start.

8/9/06

10:38 AM