Optional Accessories - Makita XSH08 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Adjusting 0°-cut or 45°-cut accuracy
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1.
Loosen the clamping screws on the front and rear
of the tool so that the bevel angle can be changed. Set
the stopper to 0° - 45° bevel angle position if you are
going to adjust 45°-cut accuracy.
1
► 1 . Stopper
2.
Make the base perpendicular or 45° to the circular
saw blade using a triangular rule by turning the adjust-
ing screw with a hex wrench. You can also use a square
rule to adjust 0° angle.
1
► 1 . Triangular rule
2
► 1 . Adjusting screw for 0° angle 2. Adjusting screw
for 45° angle
3.
Tighten the clamping screws and then make a test
cut to check if desired angle is obtained.
1
1
Adjusting the parallelism
CAUTION:
Keep the parallelism accurate.
Otherwise the circular saw blade may bite into the guide
rail and the damaged guide rail may cause an injury.
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1.
Set the tool to the maximum cutting depth.
2.
Make sure all levers and screws are tightened.
3.
Loosen the screws shown in the figure.
4.
While opening the lower guard, move the rear of
the base so that the distance A and B becomes equal.
1
► 1 . Screw 2. Base
5.
Tighten the screws and make a test cut to check
the parallelism.

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments
are recommended for use with your Makita tool spec-
ified in this manual. The use of any other accessories
or attachments might present a risk of injury to persons.
Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Circular saw blade
Rip fence (Guide rule)
Hook
Guide rail
Bevel guide
Clamp
Sheet
Rubber sheet
Position sheet
Dust nozzle
Hex wrench
Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
15 ENGLISH
1
A
B
2
Tabla de contenido
loading

Tabla de contenido