How To Use - Panasonic ES-LV6N Instrucciones De Operación

While charging
glows.
The number of the battery
capacity lamp will increase as
charging progresses.
Notes
• When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charging time may
change or the charge status lamp (
minutes. It will eventually glow if kept connected.
• Recommended ambient temperature for charging is 10 – 35 °C
(50 – 95 °F). It may take longer to charge, or the charge status
lamp ( ) will blink quickly and the battery may fail to charge
properly in extremely high or low temperatures.
• The shaver can be used for approximately 2 weeks with a full
charge.
(Based on one 3‑minute dry‑shave use per day)
The number of usable days varies depending on the following
conditions.
- Beard thickness
- Pressure applied to the skin
- Ambient temperature
- Usage frequency of the sonic vibration cleaning mode
• If there is noise from radio or other source while using the
shaver, move to a different location to use the shaver.
10
ES-LV6N_US.indb 10
After charging is completed
The battery capacity lamp and
will light up and then turn
off after 5 seconds.
) may not glow for a few

How to use

Shaving beard
1
Press and shave.
• The "shaving sensor", which automatically
adjusts the power depending on the beard
thickness, will operate.
It will shave with high power on areas where
the beard is heavy, and reduce the power on
areas where the beard is thin, to reduce
burden on the skin.
• The power cannot be turned on when the switch lock lamp
( ) blinks, as the power switch is locked.
Press the power switch for more than 2 seconds to unlock.
(See page 11.)
Tips for better shaving
Apply the whole system outer foil
perpendicularly against the skin and
shave by slowly gliding the shaver over
the face against the grain of the beard.
• The beard under the chin and around the
throat can be shaved better by stretching
the skin so the beard will stand.
• To prevent damaging the system outer
foil, do not shave with only a part of the
system outer foil.
2
Press when finished.
2015/10/29 11:27:38