Tabla de contenido
Idiomas disponibles
Idiomas disponibles
RP 210 Press Tool
Specific Safety Information
WARNING
This section contains important safety information
that is specific to this tool.
Read these precautions carefully before using the
RP 210 Press Tool to reduce the risk of electrical
shock or serious personal injury.
SAVE THESE INSTRUCTIONS!
A compartment in the RP 210 carrying case is included to
keep this manual with the machine for use by the operator.
Press Tool Safety
• Use the RP 210 Press Tool only with RIDGID Com -
pact pressing attachments (jaws, press ring, actu-
ator, etc.). Other uses or modifying the RP 210 Press
Tool for other applications may damage the press
tool, damage the attachments and/or cause personal
injury.
• Keep your fingers and hands away from pressing
attachments during press cycle. Your fingers or
hands can be crushed, fractured or amputated if they
become caught between the jaws or between these
components and any other object.
• Never attempt to repair damaged jaws, press ring,
actuator or other attachments. An attachment that
has been welded, ground, drilled or modified in any
manner can shatter during pressing resulting in serious
injury. Discard the entire damaged jaws. Replace with
new jaws. Never replace individual components except
for damaged jaw return springs. Please call Ridge
Tool Company, Technical Services for availability.
• Large forces are generated during product use
that can break or throw parts and cause injury.
Stand clear during use and wear appropriate protective
equipment, including eye protection.
• Only use RIDGID Press Tools and Jaws when
speci fied by the press fittings manufacturer. Use of
incorrect equipment and methods can cause incom-
plete joints, damage the equipment, void warranties or
cause severe personal injury or death.
• Before operating a RIDGID RP 210 Press Tool,
read and understand:
– This operator's manual,
– The attachment instructions,
– The battery/charger manual,
– The fitting manufacturer's installation instructions,
– The instructions for any other equipment used with
this tool,
4
Failure to follow all instructions and warnings may
result in property damage and/or serious injury.
The EC Declaration of Conformity (890-011-320.10) will
accompany this manual as a separate booklet when
required.
If you have any question concerning this RIDGID
– Contact your local RIDGID distributor.
– Visit www.RIDGID.com or www.RIDGID.eu to find
your local Ridge Tool contact point.
– Contact Ridge Tool Technical Service Department at
[email protected], or in the U.S. and
Cana da call (800) 519-3456.
Description, Specifications
And Standard Equipment
Description
The RP 210 Press Tool, when used with appropriate
jaws, is designed to mechanically press fittings onto tubing
to create a water-tight and permanent seal. When the
switch on the RP 210 is depressed, an internal electric
motor powers a hydraulic pump which forces fluid into
the cylinder of the tool, forcing the ram forward and apply-
ing thousands of pounds of pressing force onto specially
designed fittings. Attachments are also available for other
uses.
The entire cycle duration is approximately five (5) seconds.
Once the cycle begins to deform a fitting, it will automat-
ically continue until completion, even if the trigger switch
is released. The LED displays on the back of the tool indi-
cate problems such as improper temperature, open
attachment mounting pin or maintenance required.
Jaw Arm
LED Display
Panel (Rear)
Tool Housing
Figure 1 – RP 210-B Press Tool And Compact Series Jaw
®
product:
Attachment
Jaw
Mounting Pin
Sideplate
Scissor Style
Jaw Set
Switch
Handle
Battery
Capítulos
Tabla de contenido
