ECOFOREST VAP 100 Manual De Instalación Y Mantenimiento página 42

COMPLIANCE WITH THESE NORMS ARE OUT OF ECOFOREST'S CONTROL; ECOFOREST DOES NOT BEAR THE
RESPONSIBILITY FOR ANY RESULTING DAMAGE.
YOUR PELLET BOILER MUST BE INSTALLED AND COMMISSIONED BY AN
AUTHORIZED INSTALLER.
Although we cannot keep track of or describe every single installation, option, or the local installation
regulations corresponding to your area, Ecoforest guarantees that the installations suggested below will enable
your boiler to function properly, and to conform to minimum personal and material safety measures.
The exhaust fan can be rotated in 45 ° steps to suit a large number of installations.
To do this, we must loosen the screws of the extractor housing to be able to proceed with the said
manipulation, later, the said screws Will be re-tightened.

4 fixing screws.
5.17. The installation reflected below is the most frequent. We only have to take into account that the gas outlet
pipe located outside the boiler room complies with local regulations.

Double wall tee Ø200x90

Plug with bleed.

Stainless steel hose clamp.
5.18. If for aesthetic, safety or municipal regulations we cannot install the boiler as described above, we can
always install the pipe on the inside of the dwelling, paying special attention to the areas where the pipe
touches structures, and the minimum vertical and maximum horizontal lengths.
EXAMPLES OF FLUE INSTALLATIONS.
41

45º
Drawing 9



Drawing 10