Technical Data - HERKULES KSL 250/2 Manual De Instrucciones

Anleitung KSL 250-2 13.09.2005
GB
regulations. Repairs are to be carried out only by
qualified electricians using original replacement
parts. The user may suffer an accident if this
condition is not observed.
Be careful when making vertical cuts.
Take special care when making double miter
cuts.
Do not overload the tool!
Wear safety goggles.
Use a breathing mask on dusty jobs.
Check the tool's power cable / extension cable
for damage.
Important!
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate precautionary
measures.
Do not look directly into the laser beam with the
naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting surfaces
or persons or animals. Even a low output laser
beam can inflict injury on the eye.
Caution: It is vital to follow the work procedures
described in these instructions. Using the tool in
any other way may result in hazardous exposure
to laser radiation.
Never open the laser module.
When the device is not going to be used for
an extended period of time, the batteries should
be removed.
Wear goggles
Wear ear-muffs
Wear a breathing mask
Noise emission values
The saw's noise is measured in accordance with
DIN EN ISO 3744; 11/95, E Din EN 31201; 6/93,
ISO 7960 Annex A; 2/95. The machine may
exceed 85 dB(A) at the workplace. In this case,
noise protection measures need to be introduced
14
9:16 Uhr Seite 14
for the user (ear-muffs).
Idling
Sound pressure level LPA 89,2 dB(A)
Sound power level LWA 102,2 dB(A)
„The quoted values are emission values and not
necessarily reliable workplace values. Although there
is a correlation between emission and immission
levels it is impossible to draw any certain conclusions
as to the need for additional precautions. Factors
with a potential influence on the actual immision level
at the workplace include the duration of impact, the
type of room, and other sources of noise etc., e.g.
the number of machines and other neighbouring
operations. Reliable workplace values may also vary
from country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved."

5. Technical data

Asynchronous motor 230 V ~ 50 Hz
Input power P 1600 W
1
Operating mode
Idle speed n0 4600 rpm
Carbide saw blade ø250 x ø30 x 3 mm
Number of teeth
Standing area 460 x 220 mm
Tilting range -45° / 0° / +45°
Mitre cuts 0° to 45° to the left
Sawing width at 90° max. 115 x 90 mm
Sawing width at 45° max. 75 x 90 mm
Sawing width at 2 x 45°
(double mitre cuts) 75 x 40 mm
Laser class
Laser wave length
Laser output
Laser module power supply 2 x 1.5 V Micro (AAA)
6. Before putting the machine into
operation
The machine has to be set up in a stable
position, i.e. it has to be bolted to a workbench, a
universal stand or the like.
All the covers and safety devices have to be
properly fitted before the machine is switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
S1
60
2
650 nm
≤ 1 mW