Electrical Plugging And Adjusting The Disk Rotation Sense; Electrical Scheme - Sima PERLANATO 200 Manual De Instrucciones

4. ELECTRICAL PLUGGING AND ADJUSTING THE DISK ROTATION SENSE

Upon receipt of the machine, make sure the network electrical tension is adequate before plugging the
machine. The electrical tension is to be found on the voltage indication next to the switch of the machine.
WARNING: Never plug the machine to electricity, in case the network power tension is not the adequate
as the engine would undergo irreparable damages.
Once you have realized the previous steps it is necessary to check and adjust the rotation of the motor axis correctly,
you have to plug the machine to the electricity and start it up, watching the rotation direction that must be clockwise.
If necessary, you can change the rotation direction swapping the two phase wires in the aerial or in the peg of the
feeding extension cord. Please do it with the machine unplugged.
WARNING: Never manipulate power supply cables or any other electrical
equipment on the machine before you unplug the machine from
electricity.
WARNING: Unplug the machine from the network before proceeding to
change the position of the bridge plates on the engines. You should also
proceed to change the stickers indicating the supply voltage, so there will
always be indicated on the machine rated voltage.
The electrical equipment of the table saws has an IP54 protection
degree.

4.1 ELECTRICAL SCHEME

8