Pictograms; Transporte; Assembling Instructions; Mounting The Switch And The Legs - Sima VENUS-60 Manual De Instrucciones

2.1 PICTOGRAMS

Pictograms included in the machine entail the following:
READ INSTRUCTIONS
MANUAL
USE SAFETY GLOVES

2.2 TRANSPORTE.

The machine is packed in the factory on a pallet, easy to lift with forklifts or hand pallet trucks. Due to its
dimensions and weight (See the technical features table in this manual), it is possible to transport it in light vehicles.
When it is necessary to move the machine within the workplace once it has been unpacked, it is
recommended to empty the water from the tray before moving the machine to avoid possible splatter. It is also
necessary to block the cutting head through its device (P Fig.5) to avoid any incidental gliding that may damage it or
damage other elements. Make also sure the screws fixing the legs to the tray are perfectly tight (only PERLA 250) to
avoid them to fall off when lifting the machine.
When it is needed to transport the machine for to long distances by vehicles, cranes or other means of
elevation, the latter should be safe.
By lifting the machine with cranes or hoists, normalised slings must be used. These are chosen en function of
the required work load limit, the way of use and the nature of the load. The choice is correct if special norms of use
are respected.
ATTENTION: To avoid any possible danger, stay away from elevated loads and be careful with their possible
displacement during transport, whether during lifting or mooring. Therefore, it is essential to choose the correct slings
and remain particularly vigilant in sensitive operations (elevation, coupling, mooring or discharging).

3. ASSEMBLING INSTRUCTIONS

The Venus models are delivered in individual packing, containing in its interior the necessary accessories for
its correct mounting.
• Four legs
• Screws
• A set of keys for maintenance purposes

3.1 MOUNTING THE SWITCH AND THE LEGS

The Venus models are supported with tour legs intended to give the machine the necessary stability. These
legs are meant to be easily mounted and dismounted to facilitate the transport and the storage of the machine.
To place machine model in its normal position, it is necessary to place the four legs in its frame (P, Fig.2)
putting them up in the corresponding leg supports (T, Fig.2) of the tray using special screws (V, Fig.2), which can
be removed when needed.
The VENUS models are delivered with switch dismounted from its base during the transport; it is
indispensable to fix it with its special screws to the steel piece that covers the motor, in the position that shows on
(Fig.4 y 10.)
USE HELMET AND EYE AND AUDITIVE
PROTECTION
USE SAFETY BOOTS
- 6 -
ENGLISH