Adjusting The Cutting Head´s Bearings - Sima PERLANATO 200 Manual De Instrucciones

8.2 ADJUSTING THE CUTTING HEAD´S BEARINGS
The cart is fitted with bearings placed in the form of V. This system offers a maximum stability to the cutting
head. With the frequent use of the machine, it is possible to have to re-adjust this mechanism. You can proceed as
follows:
 Under the motor cover, there are two screws that we need to manipulate and tighten gently, to make sure
the cutting head is not moving without having to block the cart and at same the time to slide it easily. These
screws push an axis that carries 2 bearings adjusting the cart with the rolling:
WARNING: if you tighten the screws too much, you risk damaging the aluminium bridge causing an incision
where the bearings are supported. This mechanism usually needs to be adjusted with very short turns of the
screw.
14