Longitudinal Alignment - Sima PERLANATO 200 Manual De Instrucciones

8.3 LONGITUDINAL ALIGNMENT

The table saws are shipped well regulated so that when mounting the blade cut at an angle of either 90°. If the
BLADE is not aligned with the cutting bridge for any reason, you should anew align it.
 Unplug the machine from electricity and remove the disk safeguard.
 Loosen the blocking controls from both ends and with the square located on the cutting table and facing the
front side of the disk, you need observe the parallelism of both.
 Loosen the screws from the front square, place it on 90º position compared with the frame and tighten the
screws again.
15