Realising A Diagonal Cut - Sima PERLANATO 200 Manual De Instrucciones

7.4 REALISING A DIAGONAL CUT

Diagonal cutting is effectuated in the same way as a right cutting.
For a diagonal cutting, you need to use the ruler with a graduated semicircle that is supplied with the
machine. This ruler must rotate to look for required degrees to make the cutting. It has a blocking screw to fix the
desired position. Once the degrees have been selected in the semicircle, you place the piece to cut on the cutting table
marking the face of the graduated ruler as well as the front ruler upper face. To complete the cutting, proceed as per
the straight cut instructions.
12